View Single Post
Old 12-10-2017, 04:25 PM   #5
WBA2000
Eight Point
 
WBA2000's Avatar
 
Join Date: Jan 2012
Location: Right here
Hunt In: Anywhere
Default Euro mount ram head?

I use a bolt and a T-nut. Drill a hole large enough for a the T-nut to fit just in front of hole where spinal cord comes out. Put bolt thru from back of plaque and skull. Can be kind of tricky to line up T-nut and bolt but you can tighten down on it pretty good and it should not move.


I usually trim off one side to get the nut thru the spinal hole. And use forceps to insert and hold in position to thread the bolt in. Although I think I might start using all thread and a nut behind the plaque and cut it after it is tight to the plaque.

Last edited by WBA2000; 12-10-2017 at 04:51 PM.
WBA2000 is offline   Reply With Quote Back To The Top