I am going to be building some doors for my Ranger crew. After riding around this season in the cold and rain I’ve decided some doors are going to be the next project. I want them to be easily removable so I’m planning on using a bullet style weld on hinge that should work like a Jeep style door. These are going to be full doors. The idea is to build a three-quarter inch square tubing skeletal frame and sheet the bottom half with 16 gauge sheet-metal. The top half will most likely be lexan. Not sure if the lexan will be removable or not yet. They will probably be suicide style doors because the best hinge points seem to be at the rear of the doors and it’ll make for an easier latch design. That’s about as far as Ive gotten with planning and I’ll probably change things as I get further into it.
If any of you have done this or even have bought doors installed could you post some pics of the hinge and latch design.
Thanks
Sent from my iPhone using Tapatalk
If any of you have done this or even have bought doors installed could you post some pics of the hinge and latch design.
Thanks
Sent from my iPhone using Tapatalk
Comment