TexasBowhunter.com Community  Discussion Forums

TexasBowhunter.com Community Discussion Forums (https://discussions.texasbowhunter.com/forums/index.php)
-   D-I-Y Projects (https://discussions.texasbowhunter.com/forums/forumdisplay.php?f=18)
-   -   Polaris Ranger A arm and Lift (https://discussions.texasbowhunter.com/forums/showthread.php?t=455787)

R Herline Jr 05-10-2014 11:02 AM

Polaris Ranger A arm and Lift
 
I just ordered a 3'' A arm lift kit from Outkast Fabworx for my Ranger. It doesn't look that complicated. Have any of yall installed these yourselves? If so any pointers?
what not to do?
Any info would be HELPFUL

Blue Tick 05-11-2014 04:46 PM

I'm doing this to my Ranger soon as well. Good luck!

Quackerbox 05-11-2014 06:01 PM

I believe theres a few members who've done one form of these or another. Cant be that hard. Where you located Im fairly handy with tearing the hide off my knuckles and watching

Beargrizzly90 09-04-2019 08:12 PM

Never mind.. lol

Rsp 09-04-2019 08:20 PM

It’s pretty easy, most kits don’t come with new aarm bushings but a good knock with a hammer and they come out of the stock arms fairly simple. That’s about the hardest part, at least it was for me.

jathomas437 09-11-2019 03:18 PM

Pretty straight forward. Swapping out the ball joints is the worst part, but not bad with a vise or press.

day0082 09-17-2019 07:35 AM

If it is an older ranger and well used, ( the one i use to have 2011) I had to use a sawzall to cut the "A" arm bolts off and drive them out.

rjbowmaster 05-30-2020 08:59 AM

It was pretty simple, but I got my a arms with the ball joints already installed


Sent from my iPhone using Tapatalk


All times are GMT -5. The time now is 09:06 AM.

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2020, vBulletin Solutions Inc.
Copyright 1999-2012, TexasBowhunter.com