Ok, I am finally getting around to finishing this project and posting it up for your DIY guys. I built a 6' DIY Cultipacker for under $500.00. So, as promised in Ballgame's thread here you go. (For some reason I can only upload 1 photo at a time.)
Cost:
Cold roll steel - 53
T-bar Frame - scraps
Angle Brace - scraps
C-Channel - scraps
Wheels - 329.70
Pillow bearings - 46.14
Wear collar - 22.00
Caster Wheels - 15.13
Paint - 8
Tube for tire -21.03
$494.00
435lbs
Pillow block bearing and wear collar
Cost:
Cold roll steel - 53
T-bar Frame - scraps
Angle Brace - scraps
C-Channel - scraps
Wheels - 329.70
Pillow bearings - 46.14
Wear collar - 22.00
Caster Wheels - 15.13
Paint - 8
Tube for tire -21.03
$494.00
435lbs
Pillow block bearing and wear collar
Comment