Do you have an old Arizona EZFletch, that won't work on small, and micro diameter shafts?
Well here ya go. This is a simple/easy mod, that makes the jig work on shafts all the way down to .25" diameter (maybe smaller).
(1) Line the fingers of the jig with duct tape.
(2) Clamp it up on an arrow shaft to set the tape into the 1/3 round scallops for the shaft alignment.
(3) Once the tape is set/formed to fit the fingers, then trim away the excess, and slit the tape to match the fletching slits in the fingers of the jig.
TIPS:
(1) I use the O-Ring for a little extra snug at the base.
(2) Coat the tape with a thin layer of vaseline when fletching, to keep the glue from sticking where you don't want it to.
Works like a charm.
P.S.
It still works on large shafts also.
Rick
Well here ya go. This is a simple/easy mod, that makes the jig work on shafts all the way down to .25" diameter (maybe smaller).
(1) Line the fingers of the jig with duct tape.
(2) Clamp it up on an arrow shaft to set the tape into the 1/3 round scallops for the shaft alignment.
(3) Once the tape is set/formed to fit the fingers, then trim away the excess, and slit the tape to match the fletching slits in the fingers of the jig.
TIPS:
(1) I use the O-Ring for a little extra snug at the base.
(2) Coat the tape with a thin layer of vaseline when fletching, to keep the glue from sticking where you don't want it to.
Works like a charm.
P.S.
It still works on large shafts also.
Rick
Comment