Hey Bro.
Keep in mind as you look at these, that the lengths are just what I entered to get as close of a match up as I could. All are still longer than your draw length, but you should always start long, and work them down from full length about 1/4" at a time until you get them flying right for you.
Pictures in order top to bottom:
GT Trad Standard .400
GT Trad Classic .340
Easton Axis FMJ .400
Rick
P.S.
If you come across a different shaft you would like to try, just let me know, and I'll run the numbers for you.
Keep in mind as you look at these, that the lengths are just what I entered to get as close of a match up as I could. All are still longer than your draw length, but you should always start long, and work them down from full length about 1/4" at a time until you get them flying right for you.
Pictures in order top to bottom:
GT Trad Standard .400
GT Trad Classic .340
Easton Axis FMJ .400
Rick
P.S.
If you come across a different shaft you would like to try, just let me know, and I'll run the numbers for you.
Comment