There were a couple guys who liked the way I clean up switch contacts, so instead of hijacking, here it is.
I built this rig at work, and it's very simple to use
1. Wire up bad switch using the supplied forked terminals.
2. Plug in a drill motor, skill saw(without the blade), or any other high amp tool or device to the plug marked "Drill"
3. Plug the apparatus into the wall.
(Note the above pic.)
4. Squeeze the trigger on the drill.
For normally open and normally closed switches: hold down the trigger and operate the switch only.
I built this rig at work, and it's very simple to use
1. Wire up bad switch using the supplied forked terminals.
2. Plug in a drill motor, skill saw(without the blade), or any other high amp tool or device to the plug marked "Drill"
3. Plug the apparatus into the wall.
(Note the above pic.)
4. Squeeze the trigger on the drill.
For normally open and normally closed switches: hold down the trigger and operate the switch only.