Field points

[RickBarbee]

Maybe I'm just not good enough form wise to bareshaft it. I'm showing nock left with 100 grain heads at 29 inches even.

What is your fletching orientation?

Didn't think about it till just now, but you may be getting some contact at pass, which will enhance things being off some. Especially a weak spine indication.

Rick

[DRT]

3 four inch feathers. a 145 grain head gives me a bad nock left of point hit.

[DRT]

But on a bare shaft, none.

[RickBarbee]

That sound like contact.

When I asked about fletching orientation I meant:

Where is your cock fletch located?

If it is turned out at 90 degrees, turn it in at 90 degrees, and lets see what happens then.

Rick

[DRT]

Rick I'm not sure what your asking me to do. I'm trying to bare shaft tune. Fletched shafts are still at uncut length,30.5, and fly well enough.

Sent from my SM-J710MN using Tapatalk

[Bisch]

Field points

I shoot 150gr broadheads and 145gr field points. That 5gr has never made a hill of beans difference!!!!!

Like mentioned above, when I shot 5/16” shafts, I used the 5gr brass washers because they were available, and I wanted everything exact. When I switched to the skinny shafts, the washers were no longer an option, so I just do without them. There is no discernible difference if your tune is right!

Bisch


Sent from my iPhone using Tapatalk Pro

[RickBarbee]

Rick I'm not sure what your asking me to do. I'm trying to bare shaft tune. Fletched shafts are still at uncut length,30.5, and fly well enough.

Sent from my SM-J710MN using Tapatalk

Ah Gary, I missread an earlier post, and took it you are only shooting fletched.

Carry on.

[ghostgoblin22]

I bought a 24 pack of 150 grain FPs on
EBay for 10 bucks last week


Sent from my iPhone using Tapatalk