Cutting boards

[Grulla]

That walnut is a bad dude

[steve morton]

Nice

[WildMatt84]

Very nice! Where are you picking up the wood from?

Clark’s hardwood lumber

[WildMatt84]

That walnut is a bad dude

Thank you. There a couple imperfections I’m not crazy about, but it was my own fault for using the wrong blade on my table saw

[diamonde40]

Nice work sir.

[ace340cs]

Nice!!!

[Biggs]

Very nice! I also made one with my old man for mom. Mesquite and walnut. It needs some grips on the bottom.


Sent from my iPhone using Tapatalk

[WildMatt84]

Very nice! I also made one with my old man for mom. Mesquite and walnut. It needs some grips on the bottom.


Sent from my iPhone using Tapatalk

I like the contrast of those two woods. I also put feet on the bigger ones also routed handles into the bottoms

[CreekBoy]

very cool

[Canoe1]

Looks great, but be careful with adding the trim as a edge grain on an endgrain board, it can split off due to different movement of the grain.

[WildMatt84]

Looks great, but be careful with adding the trim as a edge grain on an endgrain board, it can split off due to different movement of the grain.

Thank you for the advice. I had not heard of this being an issue.

[TexasBob]

Looks awesome. Since you aren’t cutting thick material use a diablo skill saw blade on the table saw. Loads cheaper therefore you can get finer blades and swap them more often.


Sent from my iPhone using Tapatalk

[SnJGuin]

Good job

[WildMatt84]

Looks awesome. Since you aren’t cutting thick material use a diablo skill saw blade on the table saw. Loads cheaper therefore you can get finer blades and swap them more often.


Sent from my iPhone using Tapatalk

I have a thin kerf finishing blade I was just being lazy not swapping it out

[Codyo250]

looks good