Cut Pieces of sheet metal the size of the panel we wanted, ex. 4x6, 6x6. (You can also use plywood) Put a good coat of wax on it. Lay the fiber material down on it, pour the resin on it and spread it around until all the fiber is covered. Let it harden, trim the edges and peel the fiberglass sheet from the sheetmetal.
Cut Pieces of sheet metal the size of the panel we wanted, ex. 4x6, 6x6. (You can also use plywood) Put a good coat of wax on it. Lay the fiber material down on it, pour the resin on it and spread it around until all the fiber is covered. Let it harden, trim the edges and peel the fiberglass sheet from the sheetmetal.
Sent from my iPhone using Tapatalk
The way you describe the process it sounds a whole lot to do easier than I bet it really is!
Comment