Announcement

Collapse
No announcement yet.

"Back" on spine

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    "Back" on spine

    EZ7-30" dl-28 1/2 arrow-100 grain tip-what else?

    #2
    Pretty sure a .340 spine will work well.

    Comment


      #3
      Thanks, using CE blue streak, their 350. Good p.o.e, just don't like the flight.

      Comment


        #4
        What do you think the spine really is on the CE 350 blue streak, like the rest, they cover a wide range of lengths and lbs.

        Comment


          #5
          Originally posted by Tree Phantom View Post
          Thanks, using CE blue streak, their 350. Good p.o.e, just don't like the flight.
          Might not be spine.

          Comment


            #6
            Originally posted by rocky View Post
            Might not be spine.
            Might have to make the drive to your shop.

            Comment


              #7
              I have the exact same set up, ( 30" draw 72lbs Ez7)but with a 75 grain head. The CX 350 blue streaks felt like they were a little weak ( kept getting a weak spine tear). Alot weak with bh's. Cut my arrow down to 28" and stayed with 75 grain bh to get them right. Like my acc's much better than the cx.

              Comment


                #8
                Was again at a shop,(3 visits), to correct this- QAD , fletch contact, paper tune , stuff. And yes, more noticeable with bh's.

                Comment


                  #9
                  Originally posted by Tree Phantom View Post
                  Was again at a shop,(3 visits), to correct this- QAD , fletch contact, paper tune , stuff. And yes, more noticeable with bh's.
                  Have you tried a stiffer shaft in any of these visits?

                  Comment


                    #10
                    Originally posted by rocky View Post
                    Have you tried a stiffer shaft in any of these visits?
                    No I haven't. Is there a actual spine number for the 350's?

                    Comment


                      #11
                      Blues steaks are .347. All the info you need is on there web page

                      Comment


                        #12
                        Originally posted by Tree Phantom View Post
                        No I haven't. Is there a actual spine number for the 350's?
                        Well, it actually depends on how long the shaft is.
                        Spine is measured at 28 inches, but CX has always numbered their shafts differently.
                        Back when I sold lots of CX shafts, a CX 400 was a .340 spine, and a CX 300 was a .400 spine, and so on to the CX 100.
                        I don't have an actual spine tester, so I would not be able to tell you the spine of that shaft at that length.

                        Comment


                          #13
                          Originally posted by Tree Phantom View Post
                          EZ7-30" dl-28 1/2 arrow-100 grain tip-what else?
                          How many pounds is your bow set at?

                          Comment


                            #14
                            Originally posted by Putemdown View Post
                            How many pounds is your bow set at?
                            Hmmm, 70 lb,

                            Comment


                              #15
                              I think 400's would fly better with your setup.

                              Comment

                              Working...
                              X