Announcement

Collapse
No announcement yet.

Washer Board Angle Question

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    Washer Board Angle Question

    I am building a washer board set and I was thinking a 6 inch drop from the back to the front but husband thinks it should be 4. Thoughts? I don't care who is right or wrong I just want to know.

    Sent from my SM-G892A using Tapatalk

    #2
    Should be flat.

    Comment


      #3
      I'm thinking 6 inch

      Comment


        #4
        Originally posted by cwill View Post
        Should be flat.
        I am doing a single hole board, not a 3 holer.

        Sent from my SM-G892A using Tapatalk

        Comment


          #5
          The ones I have (commercial bought) have a 1.5” foot on the front and 3.5” on the back.
          Last edited by Chase This!; 04-05-2018, 02:24 PM.

          Comment


            #6
            The official cornhole rules and regulations are used for ACA cornhole tournament play as well as settling backyard disputes. The rules for the game of cornhole were developed by the original and official governing body of cornhole, American Cornhole Association.

            Comment


              #7
              washers not cornhole

              Comment


                #8
                Flat

                Sent from my SM-G950U using Tapatalk

                Comment


                  #9
                  Wow official rules for cornhole, who would have thunk it, but yeah I am looking for washers.

                  Originally thinking about just ripping a 2 x 6 and sloping it all the way to the ground, but i think at least one inch of clearance between the board and the ground is a good idea. Since I am using 3/4 inch plywood maybe i should meet in the middle and do 5 inch versus 6.

                  Sent from my SM-G892A using Tapatalk

                  Comment


                    #10
                    I thought even one hole-ers were flat.
                    But since you're only building a third of the board ... what would it hurt to slope it?

                    Comment


                      #11
                      2” difference, but I’ve played on all sorts.

                      Comment


                        #12
                        my one holers have a slope... will measure when I get home this evening.

                        Comment


                          #13
                          Originally posted by duckmanep View Post
                          my one holers have a slope... Will measure when i get home this evening.
                          tmi!

                          Comment


                            #14
                            Originally posted by Aggiechick View Post
                            I am building a washer board set and I was thinking a 6 inch drop from the back to the front but husband thinks it should be 4. Thoughts? I don't care who is right or wrong I just want to know.

                            Sent from my SM-G892A using Tapatalk
                            Washer Boards are usually flat

                            Comment


                              #15
                              Mine have a 3 inch drop. 5" in front and 8" in back.



                              Sent from my SM-G930V using Tapatalk

                              Comment

                              Working...
                              X