View Single Post
Old 04-13-2018, 02:46 PM   #17
gingib
Pope & Young
 
Join Date: Aug 2014
Location: Central Tx
Hunt In: NTX
Default

Quote:
Originally Posted by Drycreek3189 View Post
Your seeding rate does need to be increased when broadcasting but only because some of it is bound to stay on top and birds, crows, and squirrells will eat it.

My procedure goes like this:
Spray for vegetation if necessary, wait about a week to insure a good burn-down.
Disc the dead vegetation under until the plot is fluffy.
Drag the plot smooth (this somewhat packs the surface giving you a firm seedbed).
Adjust my disc gangs one position off of straight and disc just enough to cut shallow grooves in the soil.
Spread your seed and fertilizer according to recommendations.
Drag your plot once again. This will sweep most of the seeds into the "grooves" that you cut with the disc.
If you have a roller or cultipacker, run that over the plot. This is not necessary, but I like to use a cultipacker, since I have one.

This procedure has worked for me many times in the past, and all you need is a tractor, disc, broadcast seeder, and a tire drag you can make for the cost of the chain that holds it together. I have them on every place I plant. I also have the store bought drag from Tractor Supply and I prefer the tire drag.
Correct me if I am wrong but disking brings new weed seed. So what is the point of spraying if you are going to disk anyways?

I do either or
gingib is offline   Reply With Quote Back To The Top