I built one like this but made it a stand and fill. Cut those legs down to get the top to about 6 ft then add one step that you can step up on as you dump in the bag. Will never build another feeder that needs a ladder. Mine holds almost 1000 lbs of corn
Announcement
Collapse
No announcement yet.
Propane Tank Deer Feeder
Collapse
X
-
Okay taking the advice into consideration (I know nothin about metal so all comments are welcomed!) I have redrawn my design. At 81" with skids and 69" without, I'm hoping this is big enough footprint to be stable. I'd like to use 2" square tubing at the angles listed above and will gusset back with flat stock. I'll probably add another 3" at 45 deg on the end of the skids but don't like the idea of that sticking up off the ground like that.
I also plant to build a platform and ladder using the original feet of the tank as a mounting point. I'll work in that design next.
From here I just need to get the tubing and have it cut. Looks like a 24' stick will make cuts for two 75" legs and the 81" skid and leave me 57" that can be used as the platform or ladder steps.
What am I missing?Last edited by muddyz; 03-11-2017, 12:13 PM. Reason: Edited to add a landscape picture of a portrait piece of paper (eye roll)
Comment
-
Made some good progress this weekend. Got the legs on and tied into the skids as well as cut the hole for the feeder. Next step is build the platform and ladder and mount the motor. Still not sure if I'm going to just drill and tap screw the motor to the barrel of fab up some plat and weld that to the barrel.
Comment
Comment