View Single Post
Old 08-27-2014, 11:18 AM   #162
Pope & Young
Tuffbroadhead's Avatar
Join Date: Oct 2006
Location: Weatherford.....

I needed to get some boards ready for season and contacted FHA to send me some patterns that never arrived, so I then contacted NAFA and a few days later I had my new beaver pattern..

Here is a quick picture tutorial..

Two sheets of 3/4 plywood, cut into 32 inch pieces...

Cross section them so you can easily find the center of each its time to trace, its time consuming and will take a while to get done..

I started with the outer most ring and traced every board, then with scissors' cut it off to the next level and repeat till you are complete.

Last edited by Tuffbroadhead; 08-27-2014 at 11:22 AM.
Tuffbroadhead is offline   Reply With Quote Back To The Top