Thread: Stand and Fill
View Single Post
Old 07-17-2017, 01:54 PM   #12
Ten Point
big_smith's Avatar
Join Date: Oct 2006
Location: Wharton
Hunt In: Brady, Rocksprings, New Mexico

I have no idea. I just cut them at 39". I knew I wanted the base to be at least 5' wide, so I built the base, then just leaned the legs in and welded them up. I am opposed to tape measures. If I were guessing they are around 22 degrees. Also you cannot see from the front view, but there is a 1" gap below the hinge portion of the door that allows corn to run out without hanging up.

Last edited by big_smith; 07-17-2017 at 01:58 PM.
big_smith is offline   Reply With Quote Back To The Top