Announcement

Collapse
No announcement yet.

Tuning/sight help

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    Tuning/sight help

    I have a Hoyt CRX 32 set at 67 pounds. I am shooting Beman ICS Hunter Pro 340s. I was having fletching contact issues before but have resolved them by tiller adjusting the bow. Now at 25 yards which is my top pin, I'm having to raise the sight to its maximum elevation setting and also had to raise the pins themselves to get it on. What could be causing the the sight to need to be adjusted so high?

    I use a QAD Ultra Rest and D loop for release. DL 29".

    #2
    if knoc is level , then you can lower your peep a little and it will bring the sight back down.

    Comment


      #3
      Check nock height and timing. I would start there and not adjust much like peep height because then it can get uncomfortable for you

      Comment


        #4
        Nock height is level with the rest.

        Comment


          #5
          With a cam &1/2 system, the proper nock height is usually a bit higher than level. Try punching some paper. That'll give you a good idea of what your arrow is doing on release. Also, use the Berger hole/s to determine proper rest height. They are a tell of where the bow will best tune.

          Comment


            #6
            Bgrax. I don't mind helping and maybe get you headed down the right path.

            But to do this just call. 432-967-3706. If I don't answer let ring answer service will pick up leave message I'll call back.

            Comment


              #7
              Enewman, just called and left message. Thanks for your help.

              Comment

              Working...
              X