Good evening braintrust! After doing some basic tuning on my assassin I want to shorten the draw length about 3/8"-1/2". Should I just simply move the draw stop or adjust the modules? Can anyone offer me sound guidance on this? Also where should the draw stop be set to give me a good valley?
Announcement
Collapse
No announcement yet.
DL adjustment on BT Assassin
Collapse
X
-
Each # is a even DL.
#1 is 30 inches.
There is a peg that the module seats on that for each 1/2 inch, and appropriate hole.
Both cams need to be adjusted the same.
Draw post determines actual DL,(module dictates force curve), so..... set draw-stop way short to avoid overdrawing, then make small adjustments longer to reach desired let-off.
Most people have post set too long,(too much let-off).Last edited by rocky; 09-14-2011, 07:50 PM.
Comment
-
Originally posted by rocky View PostEach # is a even DL.
#1 is 30 inches.
There is a peg that the module seats on that for each 1/2 inch, and appropriate hole.
Both cams need to be adjusted the same.
Draw post determines actual DL,(module dictates force curve), so..... set draw-stop way short to avoid overdrawing, then make small adjustments longer to reach desired let-off.
Most people have post set too long,(too much let-off).
Comment
-
Move draw-stop towards limb,(shorter, down), by one -1 1/2 dots.
This will make it too short probably, with very little let-off, then in small increments after drawing after each move, move it slightly longer to desired let-off.
I have a page of specs, but never use them as I do it by feel. DON"T SET TOO LONG WITH EXCESSIVE LET-OFF.,
(nearly all Assassins have slightly different cam positions due to limb deflection), and cam position on 60s is different than cam position on 70s.
Specs are approximate.
Comment
-
Originally posted by rocky View PostMove draw-stop towards limb,(shorter, down), by one -1 1/2 dots.
This will make it too short probably, with very little let-off, then in small increments after drawing after each move, move it slightly longer to desired let-off.
I have a page of specs, but never use them as I do it by feel. DON"T SET TOO LONG WITH EXCESSIVE LET-OFF.,
(nearly all Assassins have slightly different cam positions due to limb deflection), and cam position on 60s is different than cam position on 70s.
Specs are approximate.
stop towards the limb by 1.5 dots. Then adjust stop to length and letoff feel?
Comment
-
Originally posted by ecfire1967 View PostGo with the settings in the owners manual. I adjusted my draw length and it turn out great.
Comment
Comment